Trex 600e pro build again

[Toughfedder]

Hi again,

Sorry to bother you all again but I have another query regarding my pro build. Thanks to all who replied on my last post, questioned answered.

Anyway, the main rotor head is now complete and went together lovely but I seem to have parts over. In the manual, model KX016016T, page 7 there is a bag labelled 60HH3A. Inside this bag was a socket collar screw, M3 nut and 2 x linkage balls which have all been correctly placed on the model. However also in this bag were two large shims, washers. They are large another to fit on the mainshaft. Nowhere in the manual does its state where these washers go and I am slightly worried.

Does anyone out there who is building this new kit have any advice.

Thanks again

Steve

[ChrisB]

They are shims if needed to take up slack up and down when main shaft is installed and go between top bearing and lip on shaft,they supply more than you need so no worry if you used none or have excess.