Tweet
hi i have just recieved my new copterx 50a esc and have programmed it to
1.3s li-po
2.auto throttle range
3.no brake
4.soft cutoff
5.7- for 6-8 pole motors
6.for most out runner motors 16khz
i put it on auto throttle range as only have standard tx,but when i start up it stutters a bit and then it wont spin up fully,the head speed is really slow and starts slowing down after about a minute.
the battery setting says 9v cutoff which seems to high.
cud anybody rectifiy this or recommend a better esc??oh and i have the copterx 430xl motor
thanks for any comments
Aaron
1.3s li-po
2.auto throttle range
3.no brake
4.soft cutoff
5.7- for 6-8 pole motors
6.for most out runner motors 16khz
i put it on auto throttle range as only have standard tx,but when i start up it stutters a bit and then it wont spin up fully,the head speed is really slow and starts slowing down after about a minute.
the battery setting says 9v cutoff which seems to high.
cud anybody rectifiy this or recommend a better esc??oh and i have the copterx 430xl motor
thanks for any comments
Aaron
