fancy a new plane suggestions ;D

[aparkin]

hi m8 sounds like you have 3d covered in the way of your sbach 342 and a umx beast i have a epp 3d plane great fun but only need 1 but i don't have an edf jet and i was looking at this 1

[URL="http://www.hobbyking.com/hobbyking/store/__25198__Stinger_64_EDF_Sport_Jet_700mm_Blue_EPO_PNF_UK_Warehouse_.html"]Stinger 64 EDF Sport Jet 700mm Blue EPO (PNF) (UK Warehouse)[/URL]

mow they come as 3s setup but Ive been reading and there vids ob you tube of the 4s setup and they rip the sky apart i have the rad jet and I'm feed up of killing props on and this looks like a good replacement with room to make it go faster 2 heres a 4s setup
[URL]https://www.youtube.com/watch?v=uPtJ-n3zW74[/URL]

this is a full 5 channel jet so a fully aerobatic edf jet at a good price and cose its foam you can just hot glue it back together after less than perfect landings :)

p.s check the other forums they do like this plane

[liamm =D]

[QUOTE=Darwil;941758]Flies very nice as well, it's a Trainer with clout, I'm lusting after one!!!
[url=http://www.youtube.com/watch?v=H6Fm95AoE4M&feature=youtube_gdata_player]ラジコン飛行機　Shark30Eでこんなこともできます。 - YouTube[/url]
Going for the small stuff is just the same as small helis, tend to be very twitchy, if you dumb them down with loads of expo it's ok until you need to avoid something and need plenty of stick travel, then they suddenly become an angry beast - been there broken a few that way. I'm flying a Wot4 foam-e at the moment and honestly think unless you're prepared to spend bigtime you will have a job finding anything better; mine has had a few good mishaps and with boiling water and cyano / epoxy / hotmelt still flies like a goodun!
Hope you find something you like at the right price, but my advice is don't be overambitious, I've also been there and it cost me.[/QUOTE]

thanks that 22 looks abit too fast at the moment and you right about the small planes my 2 micros are supidly twitchy but got used to them now and will take abit of the expo off :P

[liamm =D]

[QUOTE=aparkin;941761]hi m8 sounds like you have 3d covered in the way of your sbach 342 and a umx beast i have a epp 3d plane great fun but only need 1 but i don't have an edf jet and i was looking at this 1

[URL="http://www.hobbyking.com/hobbyking/store/__25198__Stinger_64_EDF_Sport_Jet_700mm_Blue_EPO_PNF_UK_Warehouse_.html"]Stinger 64 EDF Sport Jet 700mm Blue EPO (PNF) (UK Warehouse)[/URL]

mow they come as 3s setup but Ive been reading and there vids ob you tube of the 4s setup and they rip the sky apart i have the rad jet and I'm feed up of killing props on and this looks like a good replacement with room to make it go faster 2 heres a 4s setup
[URL]https://www.youtube.com/watch?v=uPtJ-n3zW74[/URL]

this is a full 5 channel jet so a fully aerobatic edf jet at a good price and cose its foam you can just hot glue it back together after less than perfect landings :)[/QUOTE]


i nealy bought one of those ages ago but i got the radjet instead but i got bored of it really quick they do look awsome tho

[one life fly it]

22 3s I would go for the acro wor foam e, I wonder if the e flight pogo takes a 2200 ? if it does they get a bit of a shift on .

[aparkin]

its on my shopping list ;)

[liamm =D]

[QUOTE=aparkin;941769]its on my shopping list ;)[/QUOTE]


ohh and the sbac and beast are ok but i hardly fly them seen as they need dead calm conditions :( i want something that can handle abit more wind than they can

[maddog7]

Hyperion Sniper X.
Expensive for a piece of sponge but cheap to kit out 1.2m wingspan. EPP, easy and cheap to fix when you stack it. Flys as much like balsa as you'll get. Fully extreme 3d capable but you can dial it down to a trainer if you like. Handles the wind well. My most flown plank.

[url]https://www.youtube.com/watch?v=aUhjHEpY4vw[/url]

When you "graduate" the Extreme Flight Edge EXP..end of.

[PKNEC]

[QUOTE=liamm =D;941721]so for all the guys who have planes on here just after a few models to look at spoke to the guys down at the field and they said a wot 4 electric but looked them up and they look abit too slow and boring dont want to buy it and after a few flights be bored of it :) aslo looked on here and found a few suggesting the parkzone extra 300 witch i like the look of and it seems a decent price i am after some thing that is nippy and can do aerobatics only plane experience i have is a radjet 800 a eflight umx sbach 342 and a umx beast so just wondering what planes i should be looking at and what other models there are apart from the parkzone :D






thanks liam[/QUOTE]


Get the Multiplex Fun Cub, tremendous piece of kit.

[liamm =D]

well so far i still like the look of the parkzone extra 300 but no one seems to have stock of them :\ but i do like the look of that acro wot mk 2 aswell and its nearly the same price :P

[aparkin]

[QUOTE=liamm =D;941771]ohh and the sbac and beast are ok but i hardly fly them seen as they need dead calm conditions :( i want something that can handle abit more wind than they can[/QUOTE]

hey my rc factory flasher is great fun 1meter wingspan made of epp bounces well and if you do rip it again it just glues back again i really love this 1
[url=http://robotbirds.com/catalog/product_info.php?cPath=29_30_204_448&products_id=6589]RC-FACTORY FLASH EPP KIT D {3}, Robotbirds[/url]

but rotbotbirds do loads

[url=http://www.robotbirds.com/catalog/images/aerobatpromo2.html]Aerobat[/url]

use uhu por at epoxy are hot glue to assemble i use cheep hk 9g digital servos and this motor

[url=http://robotbirds.com/catalog/product_info.php?products_id=6141]GF2215/20 VALUE MOTOR, Robotbirds[/url] give vertical lift at just above half throttle with nano tech 1300 3 sec lipo and a hk 30amp esc it can fly slow prop hang are it goes quite fast (not as fast as the radjet but its a 3d machine that bounces )

[URL]https://www.youtube.com/watch?v=FZoC3lxF5fs[/URL]

[Darwil]

[QUOTE=liamm =D;941765]thanks that 22 looks abit too fast at the moment and you right about the small planes my 2 micros are supidly twitchy but got used to them now and will take abit of the expo off :P[/QUOTE]
If you've got a bit of a downer on the Wot4foam-e then the Acrowot Foam -e could be good, they fly nice slow or fast and are very agile and like the Wot4 run nicely on 3s 2200's and both will fly in a fair bit of wind; been gusting up to 30mph while mine's been up; bit hairy but no real problems.

[Sharpedge]

I about to go for a Hobby King 1.4M Sbach from the UK warehouse, (yes Tom it does come with slippers, flat cap and a pipe :)

[URL="http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idproduct=32307"]Sbach 342 (Orange) EPO 1400mm (PNF) (UK Warehouse)[/URL]

Thought long and hard about the new Eflight edge QQ and the Multiplex Razzor. The Eflight is a going to be very light and requires new packs. The Razzor is a touch smaller but it can take bigger packs. The Sbach costs about the same, it is much bigger and heavier and therefore more stable in the wind. The only down side is the cheap electronics outfit that will need to be replaced at some point if you are going to get serious about banging it around the sky.

[liamm =D]

well i keep on going back and looking at the parkzone extra 300 love how it looks :D love the orange body going to ring kings lynn up tomorrow and see when they are getting the plug and play ones back in as i dont fancy getting the bind and fly one :( i do like the look of that 540 QQ tho :P

thanks for all the suggestions

[nick.m]

[QUOTE=aparkin;941761]hi m8 sounds like you have 3d covered in the way of your sbach 342 and a umx beast i have a epp 3d plane great fun but only need 1 but i don't have an edf jet and i was looking at this 1

[URL="http://www.hobbyking.com/hobbyking/store/__25198__Stinger_64_EDF_Sport_Jet_700mm_Blue_EPO_PNF_UK_Warehouse_.html"]Stinger 64 EDF Sport Jet 700mm Blue EPO (PNF) (UK Warehouse)[/URL]

mow they come as 3s setup but Ive been reading and there vids ob you tube of the 4s setup and they rip the sky apart i have the rad jet and I'm feed up of killing props on and this looks like a good replacement with room to make it go faster 2 heres a 4s setup
[URL]https://www.youtube.com/watch?v=uPtJ-n3zW74[/URL]

this is a full 5 channel jet so a fully aerobatic edf jet at a good price and cose its foam you can just hot glue it back together after less than perfect landings :)

p.s check the other forums they do like this plane[/QUOTE]

absolutly great plane is the stinger 64,,10 mins to put togeather and no gluing,,flys fantastic straight out of the box,,the esc is not that great though and you have to make sure you dont block the airway with the battery or the esc gets hot and cuts out til its cooled down,,takes a crash good too ,,my lad has but the nose on his 4 times now but out with the hot glue gun and its flying perfectly again

[one life fly it]

[QUOTE=liamm =D;941771]ohh and the sbac and beast are ok but i hardly fly them seen as they need dead calm conditions :( i want something that can handle abit more wind than they can[/QUOTE]

Have they got the as3x in them ? I have the gbee and its fine in a blow :glee: