How do i stop the blades winding up with no stick ?

[trexamanic]

we'll have a look at it tommorrow if you dont get it sorted so bring it with you if your still coming

will bring it tomorrow. what time do you guys head down?
dani_r was very helpful and i got a lot done. there are a few issues re the motor/esc but i have a spare so will try to fit today.

[dani_r]

Just try to find out what that ESC is from the guy who had the heli before you first If it's something we can programme then great! If not, the Align one is the way forward

[trexamanic]

will do mate. thanks again

[Ruston]

Have you calibrated the stick positions on the DX8? A mate had the same problem as a result of not getting a low enough throttle channel output with the throttle stick at its lowest position.

[cjcj1949]

Someone else had this problem. I think you'll find that the tx has different trim settings for each mode. When you switch on the esc remembers the trim setting as no throttle, when you switch mode by going into throttle hold it sees a slow speed. Set the trim levels the same.

[tonystevens]

will be there from about 10.30

[trexamanic]

Ok. I look forward to meeting you guys. I am not bothered about flying as I want to touch base. Will bring the 450 but I think it needs work electrically.



Sent from my iPhone using Tapatalk

[trexamanic]

Tried to pm you Tony
Your full of messages lol.


Sent from my iPhone using Tapatalk

[tonystevens]

sorry bout that, just cleared a few so try again

[unwind-protect]

What is likely happening is that your throttle hold value has been set to a negative value (say -5%). I'm not sure why they do this but they do. When you power up your heli, it reads that value as the throttle closed value, which means that when you remove throttle hold and go to 0%, it reads this as a small throttle input. BTDT.

[cjcj1949]

What is likely happening is that your throttle hold value has been set to a negative value (say -5%). I'm not sure why they do this but they do. When you power up your heli, it reads that value as the throttle closed value, which means that when you remove throttle hold and go to 0%, it reads this as a small throttle input. BTDT.

See post 20...