Honey Bee King 2 Problems

[h34ds]

Hello,

i have been flying my heli since christmas and after a bit of set up alterations has been fine and have been flying until i had a wobbly landing and the blades hit the deck and smashed one off. i have put new blades on balanced it and checked everything over, but now when i go to fly the heli takes off and spins violently.
i have tried altering the gyro and i have moved the servo on the boom further towards the main body but it still isn;t stopping it. is there anything else that can effect this?

Any help would be greatly appreciated.

Thanks

Craig

[Pipistrelli]

Have you checked to make sure all your servo's are working properly?

It is easy to break them, or damage a linkage, make sure everything operates properly before you try to fly!

[h34ds]

hello,

yes i have checked all of the servo's and they are functioning correctly, is it just spending more time finding a balance between the gyro and the boom servo? i.e does 1mm make a big difference?

[Pipistrelli]

If the heli is pirouetting, then the gyro or tail servo or linkage is not operating correctly.

Have you adjust gyro gain at all, if so reset to 50% and try it again. Its hard to diagnose without seeing it!

Another thought, just make sure tail servo operates the right way and gyro sense is correct too!

[h34ds]

ok thankyou,

yes it is spinning from tail in a clockwise direction but it is flying just spinning around constantly.

will set back to 50 and start again, thanks