Newbie further assistance please

[Zeus]

Ref my last thread purchased new Spektrum DX6I DSMX I have set up as per full ccmp setup dx6i on you tube have completed the set up as shown and have binded twice for my HK 450 3D All batteries fully charged, I have movement with the controls and can hear clicking sounds however when I ease the stick to throttle up I am getting no turning rotor blades? there fore cannot attempt to move or fly helicopter not sure what to try next........

[shades]

Get yourself to a club.... You will learn so much quicker and safer than on your own :-)

[Rob O]

Have you programmed your speed controller ? , gyro / flybarless system ? As above sounds like you may need a bit of help mate

Sent from my GT-I9505

[iceuk]

Run through the setup procedure for your electronic speed controller, if u have not calibrated it, it will not arm and engage the motor, be blood careful though mate it really does seem like you could do with a bit of help, im in bristol if that helps