Whats the crack here then?

[waveydavey]

Waveydavey - Alloy mount is 22mm front to back?? He did say he flew vbar and stuck the beast x on board just to look good for selling not plugged in and set up!! He also has throttle jocky on board - no idea? Will b fun Took a few more picks!![ATTACH=CONFIG]64819[/ATTACH][ATTACH=CONFIG]64820[/ATTACH] Like you say things don't seem to add up! - is the servo lead supposed to be outside the frame??

Beastx is a good unit, first setup can take a bit to get used to but its straightforward. Throttle jockey will be fine, setup and forget. Just noticed its the Ar7200, make sure you fit and extra satellite DSMX for a 700, channel 5 defaults to governor aux channel.

[Mark_T]

Just noticed its the Ar7200, make sure you fit and extra satellite DSMX for a 700, channel 5 defaults to governor aux channel.

Dave, you know more about the BeastX stuff than I do, but doesn't channel 5 default to the gyro gain and the gov output is on Aux 2?

[moyesboy]

Been running my BLS451 direct from 2S lipo on my 600n for a while now, first with the flybar, and now for ages with the BeastX set to whatever the beast recommended for Hz.
Great servos.
They might have a bit less load on them on my 600n compared to a 700 though...

[Mark_T]

Alloy mount is 22mm front to back??

If it helps, 22mm is the right size for a 600N elevator servo, or a 700E tail servo, but not for your 700 elevator.

I just checked the measurement against my 600N elevator mount and it is the same.

[Stunt Daddy]

Thanks Andy - will need to make sure the replacement is for the elevator and not a tail mounting which I now think it is thanks to coolice! well done guys!

[AndyThilo]

No worries, this is the one you want:

http://www.align-trex.co.uk/align-t-...t-hn7074m.html

[dannyboy123]

The DS610 is only rated to 6v. I know others have ran higher voltages but that will shorten the life of the servo and it may fail.

[Stunt Daddy]

Looking to get a reg and be done with taking any chances! needing to set this thing up right first time with no doubts in my mind!

[dannyboy123]

That sounds like a good idea to me

[Stunt Daddy]

Thanks for all your wisdom guys - much appreciated. No doubt there will be more questions.