Beastx setup help

[sunny_manku1985]

Hi guys, could anybody give me a crash course into setting up a spektrum beastx from scratch?

[DarthMole]

Best way to set it up follow the instructions in the manual.

[milly0812]

+1 the beast x is actually quite simple to setup once you've read the manual a few times. Checkout the microbeast website for the servo frequency list and write them down ;-)

[ghost2212]

Follow The manual, Its so cimple and flies so well. I recently installed one on my 550 and did everything as it said in the manual, It flew perfect staright out of the box. I havent had to change any gains at all.

[waveydavey]

Here is a link to a spreadsheet I put together for the V3 servo list, as said above follow instructions after reading a few times and you shouldn't go wrong. Make sure in menu point G you activate 1 adjustment. IE don't set 0 degrees with the led off, use this for setting your servo horns as near centre as poss then hit the rudder, 1 servo will twitch to indicate which one you're about to centre and then set centres and 0 degrees

http://www.rcheliaddict.co.uk/attachments/beastx/29874d1314379753-beastx-v3-out-now-servo-list-v3.xls

[sunny_manku1985]

Thanks for all the help guys, will hopefully be looking in to this tomorrow.

[Cuppa]

Got my Sektrum AR7200BX on my trex 500 savox tail SH1257MG Align DS510M cyclic set A-blue,B-blue,C-blue,D-blue flashing,E-end points,F-blue,G-swash level zero degrees,H-red,I-perp,J-6 degrees,K-pitch,L-cyclic limit,M-swash sensor,N-blue. Parameter menu....A-swash adjust,B-tx,blue,C-red,D-red,E-red flashing,F-blue flashing,G-perp,H-red. pots 1,2 and 3 at 1 oclock'ish +. set like this to TX you can +,- the roll/ pitch and piru rates faster-slower.

cheers
Cuppa

[sunny_manku1985]

I can not seem to find the frequency for my cyclic servos? They are savox 0257mg, and there not on the list?

[waveydavey]

Some say they're the same as the 410 and use 65Hz as the frequency. I would just make sure with beastX. Send them an email or go on the forum and ask in the technical questions and someone will answer

[Cuppa]

Savox SH-1257MG i understand to be 1520 and 333Hz

[waveydavey]

It's the 0257 John the same as the 410

[cassidy]

Theres some vids on youtube setting these up if u wanna try them?

[Cuppa]

It's the 0257 John the same as the 410

Not sure Davey, but would think slower? 410's are cyclic and the Savox HS=1257MG i have on my trex 500+AR7200BX is a tail servo.