beastx v3 issue help

[jago]

fitted beastx v3 to my 700le yesterday and maidened it today,all went well in hover just an increase the gains for tail, checked the elev/aile gain in hover all seemed to be ok so i decided it was time for gentle forward flight all seemed fine so started to put some hard pitch movements in plus then negitive, this is when i found a problem going up was fine but then when i appleyed negitive the beast put violent unwanted left aileron movement and the heli was nearly knife edge. managed to regain control then landed with a near heart failure. i did take to the air again and tried less aggressive negitive pitch movement but still did the same.

my personal opinion is the cyclic gain dial needs to be turned up but if you have an opinion it would be much appreciated thanks jago

[waveydavey]

I wouldn't you'll just make it worse. Double check your setup, make sure you haven't got a dodgy servo or nothing is tight, have you got blue light at 6 degrees etc. Be really anal about the setup

[rapidgaz]

Which mounting pad have you used and what engine do you have.


Sent from my iPhone using Internet.

[jago]

I wouldn't you'll just make it worse. Double check your setup, make sure you haven't got a dodgy servo or nothing is tight, have you got blue light at 6 degrees etc. Be really anal about the setup

cheers i will double check setup again and already checked servos they all fine and nothing is tight and also yes got blue light 6 degrees

[jago]

Which mounting pad have you used and what engine do you have.


Sent from my iPhone using Internet.

i have used the beastx mounting pad supplied and have os91hzr

[Si_B]

Are you using the pad which came with the Beast X? My 700 had a couple of scary moments, wnet through everything only to have it go out of control again. After reading around a few posts, I went with two layers of the Maplins tape with no strap. Never missed a beat since.

[jago]

Are you using the pad which came with the Beast X? My 700 had a couple of scary moments, wnet through everything only to have it go out of control again. After reading around a few posts, I went with two layers of the Maplins tape with no strap. Never missed a beat since.

yes using the pad it came with and a strapped down as well cheers jago

[rapidgaz]

Or try using the rip max tape. Also is your engine tuned or is it running rich at all.


Sent from my iPhone using Internet.

[jago]

Or try using the rip max tape. Also is your engine tuned or is it running rich at all.


Sent from my iPhone using Internet.

yes engine is tuned i flew it with 3gx for 6 months but was never fully happy with it thats when decided to give beastx ago cheers jago

[Kwickkwack]

I had a long conversation with Ade from Climb Out when I had an issue, I used the supplied pad with the middle removed and mine is just great.
The engine tune does have to be good as well.


Sent from my iPad using Tapatalk HD

[jago]

I had a long conversation with Ade from Climb Out when I had an issue, I used the supplied pad with the middle removed and mine is just great.
The engine tune does have to be good as well.


Sent from my iPad using Tapatalk HD

the engine tune is good but i used the whole pad with the centre left in cheers jago

[dszabo]

I'm using 3M tape on my 700LE. Works great.

[jago]

I'm using 3M tape on my 700LE. Works great.

sounds like alot of people are using different tape think iwill give this a try is the 3m tape you using thin say like align 3gx tape or thick like original beastx pads

[bish]

3M tape on all ours,all work perfectly.

[bish]

Thin,make sure you have no vibes and your motor is not too rich.