3Dx programming help.

[coolice]

Hey.

So it's only when upgrading you get a problem?
Are you trying to upgrade from V1.1 to V2? I wonder if you need to upgrade to V1.2 first and then upgrade to V2.
It might be worth uninstalling the current 3GX firmware and redownloading and installing it again, perhaps try V1.2 first and then download and install V2 and try and upgrade again to V2.
.

[gmurrell]

Just a suggestion on top of coolice's, are you running the firmware update before connecting the 3GX unit?

Just run the 3GX software on your PC and do the firmware updates, again I would suggest in order, so update to V1.2 first and then do the V2.0 update. Extract the files to the right folder, or at least a folder you can remember and run the update via the software. Once complete then update the 3GX unit via the write function, but always start with a blank model in the 3GX software, don't preload any of your saved settings from your current unit.

If all else fails, uninstall the 3GX software and remove all updates and then start again and reinstall the software and do all firmware/software updates before you connect your 3GX unit. This should sort all of the above issues.

regards

Gavin

[_Io]

Hi.

Hey.

So it's only when upgrading you get a problem?
Are you trying to upgrade from V1.1 to V2? I wonder if you need to upgrade to V1.2 first and then upgrade to V2.
It might be worth uninstalling the current 3GX firmware and redownloading and installing it again, perhaps try V1.2 first and then download and install V2 and try and upgrade again to V2.
.

The problem is the same if upgrade to V1.2 or upgrade to v2.0.

Thanks.

[_Io]

Bad news about theory of dropping voltage .
I configured my external BEC to 6v, the problem exist still.
After disconnect all servos the problem exist still .
I 'll follow this thread.
Thanks