Align 3gx Help

[tourerjim]

In dir mode there is correct amount of travel and no binding,in flight mode is when its got masses of travel and binding,only on elevator,aileron fine

From memory in pc software to adjust the cyclic limits would be the the first set of parameters, two are for rates & the other two for cyclic limiting.

[tourerjim]

The other thing that puzzle me is when you set up cyclic in dir your cyclic degrees for aile & elev should be about 12/13 degrees then in PC software you take the cyclic down to 8/9 & adjust cyclic rates for your style of flight.
Could be worth default tx setup & start new model as 3gx has its own memory & doesn't see changes in tx once you've done your first tx setup, I think 3gx mentions the only tx adjustments you can use once you've gone through dir.

[coolice]

Its a Trex 500pro Ian,swashplate values are

Ail +47%
Ele +47%
Pitch +37%

Hey Buddy.

Ah cool, those figures look about the norm for 99% of 3GX setups. I was just curious to know in case they ended up being quite low, which I've seen with the 600EFL's for example.

The first question I suppose is did you hit write settings ocne you'd moved the limit sliders? You may just need to move them further.

Ian

[Nick_C]

Hey Buddy.

Ah cool, those figures look about the norm for 99% of 3GX setups. I was just curious to know in case they ended up being quite low, which I've seen with the 600EFL's for example.

The first question I suppose is did you hit write settings ocne you'd moved the limit sliders? You may just need to move them further.

Ian

I did hit the write setting once slider moved lower on elevator travel limit,made no difference

[Mike Sanders]

Am I over simplifying but if you have too much travel, should you not move the ball joint on the servo arm a bit closer to the centre?

[Nick_C]

I am already on inside hole on arm,is it worth me posting a vid of it?

[coolice]

Hey Nick.

What value are you at with the PC software and still getting over driving?

On other forums it appears with V5 the overall travel ranges were increased, so it may be that the limit sliders need to be reduced more than expected to work effectively.

Ian

[Nick_C]

Hey Nick.

What value are you at with the PC software and still getting over driving?

Ian

Hi Ian,

Am at 70% on the elevator limit,if you reduce that in software it still binds and doesnt reduce limits at all