Thread: Trex 600e pro build again

Hi,

Another post, again thanks to everyone who responds.

I am in the process of building the main frame.

Q1. The MAIN SHAFT BLOCKS x2. Which way up do these face please. One side has the ALIGN markings. Do they face markings up or down.

Q2. The MOTOR PINION GEAR MOUNT. Which way up does this go, bearing facing down or up.
The manual does not show which way they go.

Q3. The motor fixes to the MOTOR MOUNT. The motor has the wires coming from it, which position should these wires be in relation to the build.

Thank you.

Steve

Q1 the writing faces up on the top block and down on the bottom.

tyjudd,

Thanks mate, much appreciated. Do you know what way the motor pinion mount goes.

Q3 I lined up the wires so that the wires came through a hole in the side frame. Can't remember what I did with Q2 and I'm not at home sorry.

Thanks buddy

have you tried to contact ben about coming over the club,if you have bring it on with you,plent of lads there to give a hand/advice

ady, Cheers mate.

vinny155, No not yet mate. I have been snowed under with work lately, I will though. Have you been over the club recently

Steve

just found your post again,yes went over today but it was just too cold,flew last weekend in the snow,cant wait for it to warm up,few degrees will do