DX6i AR600 no servo power

**Graysheli** · 13-07-2012, 08:03 PM

Hi guys still no power to my servos have plugged new servos also tried new RX throttle ok has the problem got anything to do with failsafe or can i reset my RX have tried a blank model setting too on my TX Thanks Gray

**Boggy** · 13-07-2012, 08:08 PM

Rebind? what are you using for power?

**Vikki** · 13-07-2012, 08:11 PM

Can I ask a stupid question, is your DX6i ok for DSM? I bet it worked before and I just made a tit of myself, hehehehe.

I know the AR600 isn't compatible with the DX8 and I'm not sure about the DX6i.

**Ruston** · 13-07-2012, 08:13 PM

The AR600 is ok with a DX8, it's the AR6000 that isn't. The AR6000 was pre DSM2 and isn't produced anymore.

**Vikki** · 13-07-2012, 08:17 PM

Ah, yes, I remember now that when I read that article the guy had a typo and lost an 0. Thanks for that, Ruston. I learn something every day

Vikki.

**Boggy** · 13-07-2012, 08:18 PM

confusing numbers eh? yep the AR6000 was replaced by the AR6200

**Graysheli** · 13-07-2012, 08:28 PM

Originally Posted by Boggy

Rebind? what are you using for power?

11.1V 1300 25C LiPo I Have the DX6i And DX8 Latest model When i Rebind servos dont power up!

**Ruston** · 13-07-2012, 08:36 PM

Have you got a rx battery pack you could try in place of the esc bec to eliminate a problem with the esc?

**Boggy** · 13-07-2012, 08:41 PM

Originally Posted by Graysheli

11.1V 1300 25C LiPo I Have the DX6i And DX8 Latest model When i Rebind servos dont power up!

not quite what i meant but from that i assume its from an ESC(bec)

which should be plugged into the throttle channel.not the battery port.

if you have a nimh battery around you could try and power up the rx from that(using the battery port) and see if that gives you power.

**Ruston** · 13-07-2012, 08:45 PM

Originally Posted by Boggy

not quite what i meant but from that i assume its from an ESC(bec)

which should be plugged into the throttle channel.not the battery port.

if you have a nimh battery around you could try and power up the rx from that(using the battery port) and see if that gives you power.

Great minds Boggy...off topic but you're not the same Boggy from SELOC, Pistonheads, etc are you?