Tweet
I'm in the process of setting up my new Quark gyro on my 250. I have a flash link and I'm connecting it to my Windows 7, 64 bit machine.
I have the software downloaded and installed, however, I noticed the quark setup software (Quark configuration) was not 'linked' to my quark (when I try to reverse the gyro direction it has no effect on the tail servo). I tried clicking the "detect" button and it would not seem to detect the device (it suggested the driver was not working properly).
I then downloaded the driver software from the spartan website, but when trying to run it, it kept crashing my PC (blue screening).
I then just tried to plug my flash link in and now that is enough to crash it. This time worse as it went into recovery mode on start up after blue screening.
Has anyone else has this problem? Any ideas?
Thanks,
Ollie.
I have the software downloaded and installed, however, I noticed the quark setup software (Quark configuration) was not 'linked' to my quark (when I try to reverse the gyro direction it has no effect on the tail servo). I tried clicking the "detect" button and it would not seem to detect the device (it suggested the driver was not working properly).
I then downloaded the driver software from the spartan website, but when trying to run it, it kept crashing my PC (blue screening).
I then just tried to plug my flash link in and now that is enough to crash it. This time worse as it went into recovery mode on start up after blue screening.
Has anyone else has this problem? Any ideas?
Thanks,
Ollie.