Tweet
Hey guys,
i need some help with my new 250 DFC with 3GX unit (v2.1)
basically, having gone through the set up process, everything works the way it should. Swash movent is correct when compensating movement etc... However if I apply left or right cyclic, the servos push the swash plate to its maximum position, and it seems to push them just that little bit to far that is actually binds with the mainshaft. If you look carefully you can see the top of the mast actually being moved by the force of the swash plate.
I tried altering servo end points, but this did nothing.
I then tried going through the set up process again, and altered the swash limit during the 3gx set up. It seemed to work at first, until I exited the set up mode, then it continued to bind, as if the unit had ignored my tx.
Am I missing something? Or is there something else I should try?
i need some help with my new 250 DFC with 3GX unit (v2.1)
basically, having gone through the set up process, everything works the way it should. Swash movent is correct when compensating movement etc... However if I apply left or right cyclic, the servos push the swash plate to its maximum position, and it seems to push them just that little bit to far that is actually binds with the mainshaft. If you look carefully you can see the top of the mast actually being moved by the force of the swash plate.
I tried altering servo end points, but this did nothing.
I then tried going through the set up process again, and altered the swash limit during the 3gx set up. It seemed to work at first, until I exited the set up mode, then it continued to bind, as if the unit had ignored my tx.
Am I missing something? Or is there something else I should try?
Comment