Tweet
During my brief pleasant intro in to FBL I have managed to fry my 3G unit whilst fitting a voltage reg (upon power up I foolishly plugged a 11'1 lipo direct to my RX OOP·S )
however I now have a beast x 2 flashed to 3.0 firmware
I can get to the stage of selecting radio type ie power on beast button down choosing spektrum no LED then power off
when I come to re power up I just get a red LED constant the menu LED·s flash in sequence coming to a H to N up and down run of LED·S this does not change and I dont get the swash jump at all ?
I have my DX7 set to 1 servo no trims/subtrims my RX is a AR8000 with sat.
I am assured this set up is simplicity itself and yes I do qualify on the simple bit
any input gratefully received
however I now have a beast x 2 flashed to 3.0 firmware
I can get to the stage of selecting radio type ie power on beast button down choosing spektrum no LED then power off
when I come to re power up I just get a red LED constant the menu LED·s flash in sequence coming to a H to N up and down run of LED·S this does not change and I dont get the swash jump at all ?
I have my DX7 set to 1 servo no trims/subtrims my RX is a AR8000 with sat.
I am assured this set up is simplicity itself and yes I do qualify on the simple bit
any input gratefully received