Tweet
I just installed a MKS Ds95i Tailservo on my 250 clone. it wont work. is it meant only for FBL heads? cheers Viper
-
-
you'll need to give more information that that, in what way is it not working? not at all? wrong direction? etc
It wont have anything to do with you running a FB or FBL head
I dare say its one of your gyro settings -
you need to set the correct tail frequency on your gyro or it will probably burn out the servo.I think the ds95i is 760msTrex 700n DFC - YS120, Spartan Vortex
Gaui X5 - Spartan Vortex
Comment
-
this is an initial setup on my DX8
Gyro rate = 50% with switch=on
I m using Orange Rx 6ch.
I meant by it wont respond at all to any input from the Tx.
Its connectd directly to the Gear channel to set the 90s
installed Align Ds425M and its working fine.
I just hope its not bustComment
-
Unfortunately it may well be burnt out. I haven't touched a gyro in months but I think only a few such as spartans and the align ones support the narrowband/pulse servos such as the ds95i.Originally posted by brownviper1966 View PostTrex 700n DFC - YS120, Spartan Vortex
Gaui X5 - Spartan Vortex
Comment
-
What gyro are you using? Unless it supports and is set to 760uS centre pulse, then the servo won't respond.
Off the top of my head, both Spartans, Futaba GY520, Align GP750, GP780 and GP790 gyros should all work as long as they're set correctly.Current fleet: Goblin Thunder Sport (700), Trex 700L, Logo 600, Specter 700, Henseleit TDR, V-Baaa control.
Next heli: I have pretty much everything I want. Maybe I'll upgrade some electronics or something.Comment
-
I m using quark spartan
how to set to 760us?
I m always under the impression to connect the servo directly to the Rx to set your 90s then reconnect to gyro to set the gain setting!!
have i got it all worngComment
-
If you've connected it to your RX then I'd be really surprised if you haven't fried itOriginally posted by brownviper1966 View Post
.
Trex 700n DFC - YS120, Spartan Vortex
Gaui X5 - Spartan Vortex
Comment
-
weeeeeeeeeeeeeep. its brand spanking new
how can I verify this?Comment
-
Put your quark into 760uS mode (read here on how to do this I've completely forgotten http://www.spartan-rc.com/products/q.../quark_1v0.pdf) before plugging in your DS95i and then after this is done plug it in and see if it works. If it does you're very lucky!
Trex 700n DFC - YS120, Spartan Vortex
Gaui X5 - Spartan Vortex
Comment
-
I think the servo will be okay.
If it is, once you have it connected up, set your gyro gain on the radio to a negative value (rate mode) and the servo will centre when the heli is stationary, allowing you to set the horn to 90 degrees.Current fleet: Goblin Thunder Sport (700), Trex 700L, Logo 600, Specter 700, Henseleit TDR, V-Baaa control.
Next heli: I have pretty much everything I want. Maybe I'll upgrade some electronics or something.Comment
-
phewwww, that was close I think.
I got it to work. all along it was the wrong frequency.
thanks everyone for your feedback. I ve learnt a very valuable lessonComment
Comment