Tweet
Hi all,
Another SBUS question, this time the BeastX.
So I have BeastX V3.08 with a Revlock 10 and 8FG all connected via SBUS.
I think the 8FG groups the channels in 4 channel packets, so I think I need to keep the cyclics together ideally. So, I have them grouped as follows:
1 Throttle
2 RPM
3 Remote Glow
4 Rudder
5 Rudder Gain
6 Pitch
7 Aileron
8 Elevator
The channels in red are the items plugged into the conventional channels on the R6203SB Rx.
I'll then just reprogram the BeastX to assign the correct functions etc.
Does this look right?
Another SBUS question, this time the BeastX.
So I have BeastX V3.08 with a Revlock 10 and 8FG all connected via SBUS.
I think the 8FG groups the channels in 4 channel packets, so I think I need to keep the cyclics together ideally. So, I have them grouped as follows:
1 Throttle
2 RPM
3 Remote Glow
4 Rudder
5 Rudder Gain
6 Pitch
7 Aileron
8 Elevator
The channels in red are the items plugged into the conventional channels on the R6203SB Rx.
I'll then just reprogram the BeastX to assign the correct functions etc.
Does this look right?