Announcement

**tyjudd** · 10-02-2012, 07:15 PM

Q1 the writing faces up on the top block and down on the bottom.

**Toughfedder** · 10-02-2012, 07:18 PM

tyjudd,

Thanks mate, much appreciated. Do you know what way the motor pinion mount goes.

**tyjudd** · 10-02-2012, 07:18 PM

Q3 I lined up the wires so that the wires came through a hole in the side frame. Can't remember what I did with Q2 and I'm not at home sorry.

**Toughfedder** · 10-02-2012, 07:34 PM

Thanks buddy

**ady** · 10-02-2012, 07:38 PM

the pinion bearing is at the top on mine dude

**vinny155** · 10-02-2012, 07:41 PM

have you tried to contact ben about coming over the club,if you have bring it on with you,plent of lads there to give a hand/advice

**Toughfedder** · 10-02-2012, 07:57 PM

ady, Cheers mate.

vinny155, No not yet mate. I have been snowed under with work lately, I will though. Have you been over the club recently

Steve

**vinny155** · 13-02-2012, 12:01 AM

just found your post again,yes went over today but it was just too cold,flew last weekend in the snow,cant wait for it to warm up,few degrees will do

Trex 600e pro build again