Tweet
Here is my setup file on my Logo 600 3D runnng at 2100rpm HS.
Heli setup is...
Vbar: Mini Vbar 5.2 Pro with two Spektrum satellites
Main blades: Edge 603mm FBL
Tail blades: Edge 95mm
Cyclic servos: Savox 1257's
Tail servo: Futaba BLS251
Lipos: 10S, 4500mAh
Motor: Scorpion 4035-500
ESC: Jive 80HV running Mode 4 at 80%
The setup is ideal for sports flying but the heli is agile enough for mild 3D, i.e. flips, rolls, loops, inverted etc.
I did over 30 test flights before arriving at this setup. Most of my effort was in trying out different tail settings using a Savox 1290mg servo but I couldn't get rid of a slow tail wag. When I ugraded to the BLS251 and went back to the stock settings with some some small changes - perfection.
Regards,
Patrick
Heli setup is...
Vbar: Mini Vbar 5.2 Pro with two Spektrum satellites
Main blades: Edge 603mm FBL
Tail blades: Edge 95mm
Cyclic servos: Savox 1257's
Tail servo: Futaba BLS251
Lipos: 10S, 4500mAh
Motor: Scorpion 4035-500
ESC: Jive 80HV running Mode 4 at 80%
The setup is ideal for sports flying but the heli is agile enough for mild 3D, i.e. flips, rolls, loops, inverted etc.
I did over 30 test flights before arriving at this setup. Most of my effort was in trying out different tail settings using a Savox 1290mg servo but I couldn't get rid of a slow tail wag. When I ugraded to the BLS251 and went back to the stock settings with some some small changes - perfection.
Regards,
Patrick