Tweet
I have tried searching for the answer to this without any luck...
I fitted servos, rx, etc, everything working correctly, right directions, responsive, etc so I fitted the GU365 which is where my problems started...
Firstly, does this look correct? [URL="http://rcgaui.co.uk/DX6i.htm"]Gaui 200 Gaui v2 Helicopters Gaui 255 Gaui 425 Gaui Spares[/URL]
Secondly, I'm using all DS480s so I've set the GU365 for all digital servos and I've left switch 4 on as the GU365 will be mounted horizontally.
The problems so far are:
1. Repeated failures to bind, I'm setting it up using an AR6200. The rx lights flash slowly, I release trainer switch, lights then pause, then light solid, the GU365 then iniates, goes green, sometimes red, sometimes lights and then goes out and then the rx lights flash rapidly.
2. On several occasions, the binding has worked, I've got a solid green light on the GU365, done the switch 3 setting and everything works as it should apart from the rudder servo which reponds to movements of the GU365 but manually, it will throw either way but stay at that point and not return, they only return when you put an input in...
3. The GU365 will only go green if the gyro/flap switch on the tx is on 1 (thought that was strange as the gyro is set to INH on the tx).
I won't say how many hours I've been doing this for but the bin in looking more and more inviting.
Can anybody help with the above or is there a link to a definitive set up guide.
Any assistance would be mightily welcome. :(
I fitted servos, rx, etc, everything working correctly, right directions, responsive, etc so I fitted the GU365 which is where my problems started...
Firstly, does this look correct? [URL="http://rcgaui.co.uk/DX6i.htm"]Gaui 200 Gaui v2 Helicopters Gaui 255 Gaui 425 Gaui Spares[/URL]
Secondly, I'm using all DS480s so I've set the GU365 for all digital servos and I've left switch 4 on as the GU365 will be mounted horizontally.
The problems so far are:
1. Repeated failures to bind, I'm setting it up using an AR6200. The rx lights flash slowly, I release trainer switch, lights then pause, then light solid, the GU365 then iniates, goes green, sometimes red, sometimes lights and then goes out and then the rx lights flash rapidly.
2. On several occasions, the binding has worked, I've got a solid green light on the GU365, done the switch 3 setting and everything works as it should apart from the rudder servo which reponds to movements of the GU365 but manually, it will throw either way but stay at that point and not return, they only return when you put an input in...
3. The GU365 will only go green if the gyro/flap switch on the tx is on 1 (thought that was strange as the gyro is set to INH on the tx).
I won't say how many hours I've been doing this for but the bin in looking more and more inviting.
Can anybody help with the above or is there a link to a definitive set up guide.
Any assistance would be mightily welcome. :(
Comment