Thread: Vbar tilting

Flew it 2 more times and it was fine powering up on the strip.

Quick vid of it doing the tipping.

Get the log up

How mate?

did you read post 44?

Yea, seems strange. You definitely letting it initialise?

Info>Event Log

..and Get all Entries.

Save the log it's a .pdf file, then upload it here.

Yes,i do

Will take a look at getting log up later

See if this works

Nasty vibration by the look of it.

Extreme Vibrations error messages all over the places.

The front TT gear hasn't popped out at bit? Might need clicking back in place.

If not that, starts stripping bits off.

I would imagine its a coincidence with what happened earlier, but you can get your vbar remotely checked over.

Had as lot of flights in idle up one flicking to two latley.

Its been fine the 3 flights i have had where i've not carried it to the patch.

TT gears are smooth as i had the boom off today.also took the blades and tails off and spooled up and there were no serious vibes...wonder if its the tail blades as i changed all blades together.

Will swap tails and fly it again and put the log up.

Your last flight is full of High Vibration Errors. After you powers up, it took you 2 minutes to start flying and through out the 6 min flight errors were flagging up.

It's a consistent vibe, so something is bent, outbid balance etc.

Just weighed the tails and both 4.4g

Will fit new mainshaft and feather i tomorrow.

Stripped it down and all i can find is the front tt gear has a bit of up and down play,should be able to shim it.