Thread: Spektrum Analyzer Vbar

I'm a bit concerned about high vibration messages in my Vbar log. So I thought I would investigate further. I took the main blades off and plug in a usb cable to use the Analyzer tool in the Vbar menu. Spooled it up into idle up and the highest reading is well below the yellow line. Is this ok? I take it the yellow line is the max reading that any spike should be?

sounds fine if its below the line that indicates no faults

To the right of the frequency chart is two barometers; one showing vibration number and the other the maximum vibration number.

I would recommend you change something and see what happens to those numbers.

I dynamically balanced the tail on my Logo 500. The figure started at 300. Then I made things worse and it went over a thousand. I then started getting good reults and stopped when I got the figure below 100.

The frequency chart allows you to work out where the vibration might be coming from by converting Hz (cycles / second) into rpm by multiplying the number by 60. A tail spinning at 9000 rpm with bad vibration will show as a peak at 150Hz for example.

What's your flying style? Doing 3d will showup alot of extreme vibrations