DSX 11 governor menus help please

**rachel** · 04-01-2012, 03:34 PM

Hi all I am trying to switch the governor menus on ,on this ugly TX , in fact not only is it so ugly I want to vomit its stupid too.

The governor section just isn't available in the menus it's there just in a faded way.
I have looked over device select etc etc , I even read the manual but that's no use.
Ideas anyone ? Please !!!!!
Thanks x Rachel

**WildWake** · 04-01-2012, 03:43 PM

I see this enabled at the field on saturday...
You have to go to device select, assign the gov to a channel then when you go back to the main menu the faded "gov" will be brighter, you have to set it above 50% I think for it to cut in..

**WildWake** · 04-01-2012, 03:51 PM

Also have a look at page 91,92&93 of the manual
http://www.macgregor.co.uk/support/r...x11-manual.pdf

**Steve** · 04-01-2012, 04:21 PM

Sounds the same (or very similar) as DSX9.

Once activated, you should find that your governor is controlled the flight mode switching, in the same way that the gyro gain is.

**rachel** · 04-01-2012, 05:01 PM

Thank you guys :-) I found it in " device select" menu
It's under the channels
Gear
Aux 2
Aux 3

Only I was trying to put it on aux 4 don't ask me why .
Now you guys know why I founded the "Too Stupid To Fly Model Heli" club ........

Thanks again it's simples really lol