Thread: AR7200BX setup piont K

Hi

Just checking on what the throttle curve should be when setting up collective pitch range. I have watched the video in the sticky and looked on you tube but just can't find the answer. In the manual its says; Do not use any pitch curves in your transmitter while adjusting the collective pitch range. I'm assuming this means a linear curve (0-25-50-75-100) and not flat (50-50-50-50-50) as in the manual it says must be linear (under preparing the transmitter for flybarless operation).

Just making sure as its my first Beastx unit. I must say its a very good setup process.

Thanks

Rich

Yep, just a normal linear curve.

Dan

Can either set throttle hold to have a normal pitch curve or disconnect motor from esc so it doesn't matter.

Yes just setup with a 0-100 pitch curve. Then once setup you can adjust the normal to give less negative.

Thanks guys. Was not 100% sure on what the curve should be. It made sense to be linear but just needed to double check.

Thanks again

Rich