Thread: FBL controller on 250 size heli

Hi all, Just wondered if there was any advantage of 3GX over Beastx on this size heli or vice versa? Or does size not matter here and down to personal preference? Anyone fly trex 250 with 3GX?

A BeastX is more 'tried and tested' imo.

Most of what I've seen BeastX works well on Gaui 200's

I have BeastX on my 250 it rocks

I'm beastx another chap I know has 3GX his tail is rock solid compared to mine but mine is little more stable in hover than his but 3D stuff his tracks much much better then mine also he's got same problem has me the gyro is on the bottom frame shelf & has to use long thin screwdriver down through the gear to adjust the pots.

Originally Posted by tourerjim

I'm beastx another chap I know has 3GX his tail is rock solid compared to mine but mine is little more stable in hover than his but 3D stuff his tracks much much better then mine also he's got same problem has me the gyro is on the bottom frame shelf & has to use long thin screwdriver down through the gear to adjust the pots.

Your tail problem sounds like you need to setup better in non heading hold. Know for bad tail if that's not done. Because the mechanical setup helps gyro big time.

I use 3 beastx so far and see Ern's 250 go.
That's the neat setup with out the receiver.
I know both of us use a good tail servo and the bigger tail blades

ImageUploadedByTapatalk1324532193.162556.jpg

Ern 2 's 250 flybarless

My beastx 250
DSC_0787.jpg

DSC_0834.jpg

Originally Posted by Geek

Your tail problem sounds like you need to setup better in non heading hold. Know for bad tail if that's not done. Because the mechanical setup helps gyro big time.

I use 3 beastx so far and see Ern's 250 go.
That's the neat setup with out the receiver.
I know both of us use a good tail servo and the bigger tail blades

I don't have a problem with my tail other than what I mentioned in my previous post (his tail is rock solid compared to mine) got mine setup nice not the perfect of tails but handles all the 3D